There is one Ultimaker S3 3D printer located in Sterne Library 3D Printing. The Ultimaker S3 is a dual-extruding printer.
Build Volume
(9.05 in x 7.48 in x 7.87 in)
We recommend avoiding prints that use the entire surface of the printer's build platform.
Slicer Software
The UltiMaker S3 printers are accessible in the 3DPrinterOS cloud-based 3D printer management software. All UAB students, faculty, and staff who complete required 3D printer training will have remote access to the printers managed in 3DPrinterOS.
UltiMaker-flavored Cura is available as slicing software for the UltiMaker printers. The software can be downloaded from the UltiMaker Cura website.
The design of this page was adapted in part from Research: By Course, Subject, or Topic, by University of Arizona Libraries, © 2020 The Arizona Board of Regents on behalf of The University of Arizona, licensed under a Creative Commons Attribution 4.0 International License.